Welcome to Cisco Support Community. We would love to have your feedback.
For an introduction to the new site, click here. And see here for current known issues.
is it possible to configure WPA2 on a standalone C871W? The configuration examples always talking about WPA & WEP.
Any experiences? Thank you!
I got it working on my 871w with IOS 12.4(15)T7. Hope this helps!
dot11 ssid ....myownssid...
authentication key-management wpa
wpa-psk ascii 7 ....xxxxxx....
no ip address
no ip redirects
no ip unreachables
no ip proxy-arp
ip flow ingress
ip flow egress
ip nat inside
ip route-cache flow
no dot11 extension aironet
encryption vlan 1 mode ciphers aes-ccm
speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0 54.0
no cdp enable
encapsulation dot1Q 1 native
bridge-group 1 subscriber-loop-control
bridge-group 1 spanning-disabled
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding