I'm a Cisco employee so you can say I'm professional, but this really puzzles me: I have this Cat 6506 switch with SUP720 and latest image. It takes WISM card but not WLSM, the error msg being "unsupported". I'm using 15.1(2)SY3 image and used 12.2.33-SXI13. Is that because both WLSM cards are defective?
02:03:12: %OIR-SP-4-DISABLE: Unsupported service module WS-SVC-WLAN-1-K9 in slot 4 disabled
Router#sh mod
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
2 48 CEF720 48 port 1000mb SFP WS-X6748-SFP SAL1023QB9J
3 4 WiSM 2 WLAN Service Module WS-SVC-WISM2-K9 SAL17121AUD
4 1 Wireless LAN Service Module WS-SVC-WLAN-1-K9 SAD092706LG
5 1 Wireless LAN Service Module WS-SVC-WLAN-1-K9 SAD084301HU
6 2 Supervisor Engine 720 (Active) WS-SUP720-BASE SAD072600D0
Mod MAC addresses Hw Fw Sw Status
--- ---------------------------------- ------ ------------ ------------ -------
2 0018.1854.578c to 0018.1854.57bb 1.5 12.2(14r)S5 15.1(2)SY3 Ok
3 f0f7.5569.6c98 to f0f7.5569.6ca7 1.1 12.2(18r)S1 15.1(2)SY3 Ok
4 0014.f22b.e0c2 to 0014.f22b.e0c9 1.0 Unknown Unknown PwrDown
5 0003.3234.d5c0 to 0003.3234.d5c7 1.0 Unknown Unknown PwrDown
6 000c.ce63.fb84 to 000c.ce63.fb87 2.3 7.7(1) 15.1(2)SY3 Ok
Mod Sub-Module Model Serial Hw Status
---- --------------------------- ------------------ ----------- ------- -------
2 Centralized Forwarding Card WS-F6700-CFC SAL1026SXT8 2.0 Ok
6 Policy Feature Card 3 WS-F6K-PFC3A SAD0728017X 1.2 Ok
6 MSFC3 Daughterboard WS-SUP720 SAD072801RW 1.5 Ok
Mod Online Diag Status
---- -------------------
2 Pass
3 Pass
4 Not Applicable
5 Not Applicable
6 Pass
