I installed two 6000P cameras today. Both had old firmware so I downloaded the most recent 1.4.x firmware release onto the first one, but the media server kept complaining that it could not connect to the camera (it is reachable, and I can get in with a web browser).
On a hunch I installed the older 1.3.x firmware onto the other one since that is what my other 6000P is running and sure enough it worked fine.
My question is how does one downgrade firmware on an IP Camera? I want to bring the camera running 1.4.x down to the working 1.3.x version.
The cameras I have running the previous version show up in VSM 7. This newest firmware will not stream for some reason. So I figure I should install the same firmware as my working cameras. But not certain how to "roll back" to a previous firmware version.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...