Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CIAC-GW-K9

photo.JPG

Does anyone know what these series of lights signify? This was out of the box, and we are trying to configure this with POE, however the switchport does not come up. Its connected to a 3560 POE.

No CDP or link light on the gateway or the switch.

Also, the hard and soft reset do not work.

Thanks

3 REPLIES
Silver

CIAC-GW-K9

Hmmm... according to the datasheet, this *should* work via PoE...

http://www.cisco.com/en/US/prod/collateral/vpndevc/ps6918/ps9674/ps9687/datasheet_C78-464240.pdf

... but doesn't neccessarily list PoE under the power options.

Anything noted in the message log of the switch? Something is ringing a tiny bell in the back of my mind regarding non-MediaNet switches and PoE (what's the exact model of the switch?). 

I recall an IPVS client having to rig up some specific switchport power settings to get his IP Cameras to power up properly. 

I'll see what I can dig up later today.

Scott Olsen Solutions Specialist Bulletproof Solutions Inc. Web: www.bulletproofsi.com
Silver

CIAC-GW-K9

My bad.  I was looking at Table 2 in the datasheet (which is only describing device connectors).  The datasheet does properly list 802.3af PoE as a valid power source in Table 4.

Scott Olsen Solutions Specialist Bulletproof Solutions Inc. Web: www.bulletproofsi.com
Silver

CIAC-GW-K9

Have you had a chance to check the switch logs?  If you see something similar to:

ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error, Interface Fa0/12: Power given, but link is not up

... try adding the following to the switchport config:

power inline delay shutdown 20 initial 100

Scott Olsen Solutions Specialist Bulletproof Solutions Inc. Web: www.bulletproofsi.com
924
Views
0
Helpful
3
Replies