Tool does allocate IP address to a single 2500 camera however nothing is displayed in the discovery tool. Only one interafce is enabled and the rest are disabled. Local interface does have ip address of 192.168.0.2/24. What am I missing? Also what would be the best logical procedure in configuring 20 camera, i.e bulk configuration? If the camera is plugged into a Cisco switch and DHCP is enabled then by default (Out of the box) will CDP discover this on the switch and tell me its IP address details by show cdp nedighbours detail or do I have to enable CDP on the camera before it displays layer 3 configuration?
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...