It powers up fine, I can navigate to the webpages to configure it, upgraded it to the latest version of firmware (2.1.5). But there is no image displayed (under the 'home' link when I surf to the ip address.
I have two brand new ones, both exhibit the same problem. I feel like there's some sort of simple configuration issue I'm missing, any advice would be appreciated. Thanks!
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...