12-19-2013 09:31 AM
Has anyone ran into this problem. I have a 2RU that we replaced the drive in 2 weeks ago and the drive has never completed the rebuild and is stuck in that state.
12-19-2013 09:39 AM
Is it *actually* in a rebuild state? How are you monitoring it?
Open a shell and check the following:
/opt/MegaRAID/MegaCli/MegaCli -pdlist -a0
review the output and locate the "block" of data that represents the slot/drive you've recently repaced. What state is it in?
If it's in rebuild state, you can check it's actual status with:
/opt/MegaRAID/MegaCli/MegaCli -pdrbld -showprog -physdrv "[
Let me know. There may be a few things we could explore.
Cheers!
12-19-2013 09:54 AM
I would add that I have seen this. As Scott says first verify that it is in fact in rebuilt. In my case it was phsycally slotted but did not ever begin the rebuilt. I simply pulled it out and slotted it again (this time quite firmly) and it began to rebuild after that.
12-19-2013 01:17 PM
Thanks for the responses guys.
I had tried the reseat and checking the status using MegaCLI cmd and everything is functionoing properly. No errors or anything. Just that the Virtual Disc 2 is degraded on that particular slot. Everything else is functioning properly and archives and happily chewing up space. I have scheduled to upgrade this client over the next to weeks from 7 - 7.2.1. I have a felling that I will rebuilt this server and then upgrade it from scratch.
12-27-2013 09:51 AM
Check make sure you have correct HD installed in that slot
Also when in doubt reboot the server and check server health state.
12-31-2013 05:51 AM
Already did that. However, I rebuilt from scratch and everyting is working properly. This is the third instance of this particular problem that I have ran into on the older MSP-2RU line.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide