Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Configuring motion detection in CIVS

Hi i have CIVS with Cisco IP Camera 4300 series. Can anyone tells me how to configure motion detection in CIVS.

Requirement: Camera should archive the clips in VSOM when there is a motion detection.

6 REPLIES
New Member

Re: Configuring motion detection in CIVS

Steps to configure motion detection are in the VSOM User Guide located at the http://www.cisco.com/en/US/partner/products/ps9153/products_user_guide_list.html

The Configuring, Editing, and Deleting Events section can assist you with configuring the VSOM. Make sure you enable motion detection of the Camera Feed.

New Member

Re: Configuring motion detection in CIVS

Can VSM do motion recording, not just motion "tagging" in a looping archive?

The difference is that with motion recording video with motion is the only thing recorded. We can allocate the amount of disk space my % of motion, opposed to recording 100% of the time and just tagging the motion for video search and retrieval purposes.

New Member

Re: Configuring motion detection in CIVS

The Steps to configure motion detection are loacted in the "Cisco Video Surveillance 4000 IP Camera End User Guide" at URL http://www.cisco.com/en/US/partner/products/ps9716/products_user_guide_list.html

See page 3-11 Event notification.

New Member

Re: Configuring motion detection in CIVS

Hi,

I have connected a 2500W IP Camera to VSM and set up a Window in Motion Config and activate "Start Archive" under Motion Start->Archives.

If I check the Camera Feed in the list of feeds VSM will create a 5min LoopArchive where the events will be tagged, if i check an existing archive from the running Archives list, my events will be tagged there.

Problem is: If I want Event triggered Recordings of only the times when an event occurs, I have to go to Operator View, search the event, and press "Create Clip" manually.

How can I set up VSM to automatically create a single clip of every Motion detected, instead of only tagging the events in a loop Archive?

For a Record now event a new clip ist created, too. How can I have this functionality for Motion triggered Events.

I tried this for 4.2.1/6.2.1, but got this issue on a Customers 4.2/6.2, too. I believe I got this working in older releases...

Thanks in Advance

Regards
Dirk

New Member

Re: Configuring motion detection in CIVS

I'm curious about this as well.

New Member

Re: Configuring motion detection in CIVS

Just for the sake of anyone else:

Series 2000 Motion Detection:

  • Use the Navigation Tree to access each configuration window...

  • Navigate to the Application > Motion Detection menu…

  • Enable Motion Detection...

Series 4000 Motion Detection:

  • Click View Video in the IP Camera Main window menu bar. The Camera Video/Control window appears.

  • This window displays live video from the camera and lets you control a variety of camera and display functions including the Motion Detection.

  • Enable Motion Detection...


1543
Views
0
Helpful
6
Replies
CreatePlease to create content