I have a challenging problem. I have 2 Cisco Gateways. If I have a device on gateway 1 input 3 that needs to unlock a door lock on Gateway 2, how would I accomplish this? Gateway 2 was out of input ports, so the trigger had to be installed on a different gateway. The input on gw1 is normally open, so when they push the button, it needs to unlock Door 2 on Gateway 2. Any help would be much appreciated.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...