cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2518
Views
0
Helpful
7
Replies

Cpam- Door State Inconsistent

philtraylor
Level 1
Level 1

Anyone know why on earth I would get this error?

I have a couple doors showing alarms for  "Door State Inconsistent"

I can not seem to figure out why. All the devices associated to the door are functioning properly...

Thanks!

Phil

7 Replies 7

mcwalter
Level 3
Level 3

Which input triggering the door state inconsistent event?

I can not tell. Further examination of the alarm does not seem to specify which input point is causing the issue.

What am I missing?

You may want to run a system sanity report. It may tell you where the error is. Good luck.

Good call. I will check there. Thank you!

Hi,

I have the same issue at the minute. Have you had any further help on this?

Kind regards,

Finbarr

I have not gotten much luck in this area, I ended up disabling this alarm entirely.

wsmith3212
Level 1
Level 1

Generally I have found that a motion REX that is incorrectly configured to trip the lock in a high traffic area can pop the lock when the door isnt being used causing that alarm.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: