Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cpam- Door State Inconsistent

Anyone know why on earth I would get this error?

I have a couple doors showing alarms for  "Door State Inconsistent"

I can not seem to figure out why. All the devices associated to the door are functioning properly...

Thanks!

Phil

7 REPLIES
New Member

Cpam- Door State Inconsistent

Which input triggering the door state inconsistent event?

New Member

Cpam- Door State Inconsistent

I can not tell. Further examination of the alarm does not seem to specify which input point is causing the issue.

What am I missing?

New Member

Cpam- Door State Inconsistent

You may want to run a system sanity report. It may tell you where the error is. Good luck.

New Member

Cpam- Door State Inconsistent

Good call. I will check there. Thank you!

New Member

Cpam- Door State Inconsistent

Hi,

I have the same issue at the minute. Have you had any further help on this?

Kind regards,

Finbarr

New Member

Cpam- Door State Inconsistent

I have not gotten much luck in this area, I ended up disabling this alarm entirely.

New Member

Cpam- Door State Inconsistent

Generally I have found that a motion REX that is incorrectly configured to trip the lock in a high traffic area can pop the lock when the door isnt being used causing that alarm.

1595
Views
0
Helpful
7
Replies