I currently have a gateway with 15 additional reader modules connected to it. All reader modules are being detected by the Gateway and I have been able to configure doors to each module. I am using a two reader module configuration. I have configured 32 Doors for this gateway and sent through the configuration. Module M15 appears to be configured on CPAM, but when you check the doors associated with it they have not received the configuration. The LED's on the associated reader module are also off for inputs andd outputs. I have checked termination across the CAN Bus ans all looks good. The reader module in question is located adjacent to the Gateway module, so distance is not an issue.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...