I've tried upgrading using both the Upgrade tool available in 6.3 and the cameras upgrade interface. The VSMS tool reports success but the camera web page and interface shows no difference. The cameras upgrade feature replys "Bad magic number". I turned off motion events and all other items that may interfere.
Dustin, What version of the firmware are you upgrading FROM? I've had some issues when upgrading from a firmware that is non-standard. That it I've been given firmwares by either TAC or the BU to address certain problems that have never been officially released for download. When trying to upgrade these it was first necessary to revert to a previous official release (say 1.03) before the upgrade would work. Hope this helps!
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...