Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

issues with the bandwidth consumption for router 2811 and 2901 with IPICS solution

We have  IPICS 4.0.2 and would like to know if any of you have problem with integration of router RMS and LMR in the same router

the proble is when we have router 2811 the bandwidth consumption is greater at difference the bandwidth consumption for a 2901 roter.

in reality the interfaces of the routers 2811 and 2901 are different in the 2811 the interfaces are Fastethernet and in the 2901 are GEthernet , but the interfaces in both case is the same result:

reliability 255/255, txload 1/255, rxload 1/255

I noticed that the traffic generated for the 2811 is greater at difference of the 2901 as see in the interfaces:

2901 interfaces:

GigabitEthernet0/0 is up, line protocol is up

  Hardware is CN Gigabit Ethernet, address is d0d0.fd76.a1e0 (bia d0d0.fd76.a1e0)

  Description: link to  XXXXXXXXXXXXXXX

  Internet address is XX.XX.XX.XX/xx

  MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec,

     reliability 255/255, txload 1/255, rxload 1/255

  Encapsulation ARPA, loopback not set

  Keepalive set (10 sec)

  Full-duplex, 1000Mb/s, media type is RJ45

  output flow-control is XON, input flow-control is XON

  ARP type: ARPA, ARP Timeout 04:00:00

  Last input 00:00:00, output 00:00:00, output hang never

  Last clearing of "show interface" counters never

  Input queue: 5/75/0/0 (size/max/drops/flushes); Total output drops: 2

  Queueing strategy: Class-based queueing

  Output queue: 0/1000/0 (size/max total/drops)

  5 minute input rate 23000 bits/sec, 23 packets/sec

  5 minute output rate 23000 bits/sec, 23 packets/sec

     2702768 packets input, 366237389 bytes, 0 no buffer

     Received 20951 broadcasts, 0 runts, 0 giants, 0 throttles

     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

     0 watchdog, 0 multicast, 0 pause input

     0 input packets with dribble condition detected

     2900046 packets output, 383056409 bytes, 0 underruns

     0 output errors, 0 collisions, 0 interface resets

     0 unknown protocol drops

     0 babbles, 0 late collision, 0 deferred

     3 lost carrier, 0 no carrier, 0 pause output

     0 output buffer failures, 0 output buffers swapped out

2811 interface

FastEthernet0/0 is up, line protocol is up

  Hardware is MV96340 Ethernet, address is 18ef.6347.d310 (bia 18ef.6347.d310)

  Description: link to XXXXXXXXXXXXXXX

  Internet address is XX.XX.XX.XX/xx

  MTU 1500 bytes, BW 100000 Kbit/sec, DLY 100 usec,

     reliability 255/255, txload 1/255, rxload 1/255

  Encapsulation ARPA, loopback not set

  Keepalive set (10 sec)

  Full-duplex, 100Mb/s, 100BaseTX/FX

  ARP type: ARPA, ARP Timeout 04:00:00

  Last input 00:00:00, output 00:00:00, output hang never

  Last clearing of "show interface" counters never

  Input queue: 5/75/0/0 (size/max/drops/flushes); Total output drops: 0

  Queueing strategy: Class-based queueing

  Output queue: 0/1000/0 (size/max total/drops)

  5 minute input rate 1000 bits/sec, 1 packets/sec

  5 minute output rate 485000 bits/sec, 250 packets/sec

     41309150 packets input, 1232495052 bytes

     Received 32 broadcasts, 0 runts, 0 giants, 0 throttles

     2 input errors, 0 CRC, 2 frame, 0 overrun, 0 ignored

     0 watchdog

     0 input packets with dribble condition detected

     643401943 packets output, 3440311538 bytes, 0 underruns

     0 output errors, 0 collisions, 0 interface resets

     0 unknown protocol drops

     0 babbles, 0 late collision, 0 deferred

     0 lost carrier, 0 no carrier

     0 output buffer failures, 0 output buffers swapped out

is assumed to be the same traffic with the two routers different.

Any ideas?

1015
Views
0
Helpful
0
Replies
CreatePlease login to create content