cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1845
Views
0
Helpful
1
Replies

Low Level Elevator Security Interface with Physical Access Control

paulw.wilkinson
Level 1
Level 1

Hi,

We have an existing access control system that we are looking to replace with the Cisco solution.  Part of the current system is elevator access control.

This has a reader in each elevator car and a relay card that has one relay for each of the six access controlled floors.  These relays close a circuit that is supplied from the elevator control system.

I am wondering how I can acheive this integration using the Cisco solution. Ideally we would be able to control access to each floor individually, but I am not sure how to have a single reader associated with what is effectively six different 'doors'.

Thanks,

  Paul

1 Reply 1

galaxyct1
Level 1
Level 1

It can be done with some creativity using I/O rules with an output module attached to an access gateway.

Please contact me offline to discuss further.

Thanks,

Ben

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: