Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Restore Factory Default Settings on a 6020 camera

Hi,

Anybody knows if the "Restore Factory Default Settings" button erases the IP configuration of the camera? I know it's mentioned on the web page of the camera. But the TAC told us to do it, while troubleshooting a firmware issue, on a remote camera.

thanks.

 

1 REPLY
Silver

I'm fairly certain that this

I'm fairly certain that this will absolutely reset the camera back to a factory fresh state... including any static addressing information:

"

Restore button

Click the Restore button to reset all IP camera settings to their factory
default values.
To confirm the restore procedure, click OK in the confirmation pop-up
window. Otherwise, click Cancel.


This action has the same effect as pressing and holding the Reset button on
the IP camera for at least 15 seconds. After you perform this procedure,
follow the steps in the Chapter 2, “Performing the Initial Setup of the IP
Camera.”

"

 

Scott Olsen Solutions Specialist Bulletproof Solutions Inc. Web: www.bulletproofsi.com
231
Views
0
Helpful
1
Replies