Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Using the CISCO3845-AVG-64 3845 Video Encoding Bundle with 4 EVM-IPVS-16a for 64 ports, IP Base, 64MB Flash and 256MB DRAM

Anyone ever used this module?

I am looking for documentation on it but not finding it on Cisco's site other than the datasheet which doesnt have the detail I need.

Do any of you know if I need 4 GigE connections for all 4 modules?

Thx

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: Using the CISCO3845-AVG-64 3845 Video Encoding Bundle with 4

Here are a few links that might point you in the right direction:

http://www.cisco.com/en/US/docs/routers/access/interfaces/nm/hardware/installation/guide/videvm.html

http://www.cisco.com/en/US/partner/docs/video/cavg/rel1_1/administration/guide/cavgadmin.html

http://www.cisco.com/en/US/partner/docs/video/cavg/rel1_1/xml_api/guide/panoxml.html

http://www.cisco.com/en/US/partner/docs/video/cavg/rel1_1/installation/guide/cavginstall.html

I know there is more documents out there but I haven't found the links for them.

The first link indicates that you can use the gig port on the module as an additional router port.  I've haven't been able to find it again but I thought I had read that this port has been disabled in a newer software release.

That first link also shows an example of how to use one of the main router ethernet ports for the AVG modules.  Each module gets an IP address and can router its  traffic through the router ethernet port.

Hope this helps.

Andrew

1 REPLY
New Member

Re: Using the CISCO3845-AVG-64 3845 Video Encoding Bundle with 4

Here are a few links that might point you in the right direction:

http://www.cisco.com/en/US/docs/routers/access/interfaces/nm/hardware/installation/guide/videvm.html

http://www.cisco.com/en/US/partner/docs/video/cavg/rel1_1/administration/guide/cavgadmin.html

http://www.cisco.com/en/US/partner/docs/video/cavg/rel1_1/xml_api/guide/panoxml.html

http://www.cisco.com/en/US/partner/docs/video/cavg/rel1_1/installation/guide/cavginstall.html

I know there is more documents out there but I haven't found the links for them.

The first link indicates that you can use the gig port on the module as an additional router port.  I've haven't been able to find it again but I thought I had read that this port has been disabled in a newer software release.

That first link also shows an example of how to use one of the main router ethernet ports for the AVG modules.  Each module gets an IP address and can router its  traffic through the router ethernet port.

Hope this helps.

Andrew

537
Views
0
Helpful
1
Replies