Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

VSOM camera feed error Endpoint error p_s1_Camera_name_1unreachable

Hi,

I have deployed 7 Cisco IP camear 2421 out of which 6 are working fine. All these cmera are configured into Cisco VSOM. For 6 camera I am able to view the video in VSOM ops page. But for one camear VSOM displays error Endpoint error p_s1_Camera_name_1unreachable and unable to view the video. For the same camera I am able to ping it & take it web access by IP. Also its video is available through web access.

Please help why this error is coming in VSOM?

Regards,

Abhas Jain

Everyone's tags (5)
7 REPLIES
Community Member

Re: VSOM camera feed error Endpoint error p_s1_Camera_name_1unre

The 6 working units - How did you input those IPCs into VSOM? Did you install 1 IPC and then copy or did you do 1 by 1?

-Did you logout of the IPC and then go into VSOM to controll the IPC?

-Try stopping and restarting the VSM

I experienced this same error with deployment of CIVS-IPC-2500 and to correct it I did the following:

--Removed special characters from pwd in IPC and VSOM

- Set complexity to 3 $ 4

--Enabled HTTP for the camera as vsom doesnt use HTTPS

-updated the FW from 1.1.1 to 2.1.2

-Check the sys logs on IPC and VSOM - what do they report?

Community Member

Re: VSOM camera feed error Endpoint error p_s1_Camera_name_1unre

HI

I tried above mentioned options but still facing same problem. This problem is only with one camera & remaining cameras are working fine. Please suggest solution to resolve this,

Regards,

Abhas Jain

Community Member

Re: VSOM camera feed error Endpoint error p_s1_Camera_name_1unre

Hello,

-Can you provide further details on the camera configurations and variables, please?

-Have you view the Sys Log from the VSM/VSOM and camera? Capture the sys log

-The drivers are good as you have 5 other IPCs up and running correct?

-You verified from the VSOM/VSM you can ping the camera? I know you can reach the camera from the network - but the VSOM creates a proxy feed to each IPC and you need to verify that the VSOM is able to physically reach the end point device.

-It is not an issue with the specific camera/hardware? If you swap configurations from "Working" $ "NON-Working"  what is the result?

-Another thread indicated possible DNS? Have you check your DNS settings?

-

Community Member

Re: VSOM camera feed error Endpoint error p_s1_Camera_name_1unre

Delete that camera from VSOM, synch and add it again

Bronze

Re: VSOM camera feed error Endpoint error p_s1_Camera_name_1unre

I would verify the firmware on the camera in question. I had the same problem with some 2500s where they had the old firmware.

Community Member

Re: VSOM camera feed error Endpoint error p_s1_Camera_name_1unre

has there been a resolution to this? i seem to be running into the same problem and i am using the latest firmware on VSOM/VSMS and 2500s

Community Member

Re: VSOM camera feed error Endpoint error p_s1_Camera_name_1unre

I've had the same problem.  Try logging into the web interface of the 2500 in question and doing a manual restart.

2941
Views
0
Helpful
7
Replies
CreatePlease to create content