This trying to prepare two servers with the application cisco prime 8.3 but I am having problems to finish raising the sercio
The Regional cluster, lifted the service and from a browser entered the IP address: 8080 and I get a window where I must enter a user and a password try with the user nradmin but I do not know the password I wanted to register a new user and password And I think that the name of the cluster is incorrect the seridores are running with CentOS
If someone already managed to raise the service please please show me what I'm missing or what is my mistake
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.