PCP v10.5 does not set call forwarding on Service Template Import
I'm trying to import service templates into PCP 10.5. I'm able to get a Line template import to succeed but the call forwarding settings I specify in the import file are being ignored.
I'm not 100% sure of the syntax since it does not appear to be documented and the examples do not include call forwarding settings. I received an error message that said the forwarding must be in the format of Destination:Voicemail:Calling Search Space. I've tried the following:
(System Internal is a valid CSS)
All result in the batch job succeeding and service template being created but the forwarding settings are not applied.
I've attached the template. Any assistance would be appreciated
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...