Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Prime Assurance 9.5 SP1 - MGCP E1 Utilization

I have installed Cisco Prime Collaboration Assurance and Analytics 9.5 SP1. In the dashlet Top 5 Utilized Trunks/Route Groups i can see all of my E1 Ports, but the Utilization value is always 0%. I have seen in OM 9.0 a similar dashlet, which shows in real time the utilization. Shouldn't this also be shown in Prime 9.5?

Everyone's tags (1)
5 REPLIES
Purple

Hi, Can u please check under

Hi,

 

Can u please check under Administration ---System Setup ---Assurance Setup ---CDR Trunk Utilization Settings whether MGCP Gateway is selected or not ?

 

regds,

aman

Bronze

Hi, Did this solve the

Hi,

 

Did this solve the problem?

 

Also, to enable trunk utilization is there any specific configuration required on the VG?

 

Thanks!

-JT-

 

Cisco Employee

  No specific config is

 

 No specific config is required on the VG for this.  We just need to have snmp access to the VG 

 

thx
Prem

Bronze

Hi Prem, Is it the same

Hi Prem,

 

Is it the same process for monitoring SIP trunks on CUBE?

 

Thanks!

-JT-

Cisco Employee

   For CUBE SIP trunks you

 

  For CUBE SIP trunks you need to configure the maximum capacity for the SIP trunks

in prime collaboration. YOU can do that by going to the infrastructure dashboard and then above the Top 10 Trunks dashlet you will see a link that says "Utiliztion Settings". 

Click on that and you can set the max capacity there.

Once that is done then Prime Collab will calculate the SIP Trunk Utilization and display it

thx

159
Views
0
Helpful
5
Replies
CreatePlease to create content