Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Using CVP on Cisco Prime Assurance 10.5

Hello guys,

I'm trying to add CVP 8.5 to be monitored by Cisco Prime Collab. Assurance 10.5, and after added the IP and SNMP RO, it shows that the SNMP credentials does not match.

Is everyone else getting this issue on this new version?

Thanks in advance

Everyone's tags (1)
2 REPLIES

i have never worked on Cisco

i have never worked on Cisco Prime but yes CVP supports snmp monitoring.

did you configure snmp community string and notification destination in CVP ops console and apply it to all the CVP devices.

 

in addition, configure snmp for windows also, it will be disabled but required for snmp to work.

 

regards

Chintan

New Member

I have two instances of CVP -

I have two instances of CVP -- one in Production and another in TEST.  The Production one I have had working with CUOM via SNMP for a while. In testing Prime I was setting up the TEST environment and found I couldn't add the SNMP string to any devices as non were listed in OAMP, but I was able to copy the SNMPD file (it actually is SNMPD.conf but Windows assumes that it is of type "Speed Dial" and hides the extension -- even if you have show extensions turned on in Windows Explorer) from my working Production environment to TEST and it worked.

However, I now am stuck at failing the HTTP authentication -- is this the CVP OAMP user? Local Windows account?

 

Thanks,

Mark

87
Views
0
Helpful
2
Replies
CreatePlease login to create content