02-25-2009 02:29 PM - edited 03-06-2019 04:15 AM
I have in the network switches 2960 and 3560, but don't can type in CLI the duplex full, speed command.
the IOS in the switches is 12.2(35)SE5
thanks.
SW_NEIV_01(config)#inter gigabitEthernet 0/2
SW_NEIV_01(config-if)#
SW_NEIV_01(config-if)#
SW_NEIV_01(config-if)#du
SW_NEIV_01(config-if)#duplex?
% Unrecognized command
SW_NEIV_01(config-if)#duplex full
^
% Invalid input detected at '^' marker.
SW_NEIV_01(config-if)#speed
^
% Invalid input detected at '^' marker.
SW_NEIV_01(config-if)#
Solved! Go to Solution.