02-07-2012 08:00 AM - edited 03-04-2019 03:10 PM
Hi dear,
I have attached setup like this :-
This is the same scenarioa as ASA with Dual WAN setup. But my requirement is different. I have added in ASA and configure sla is asa, all working fine. When one link goes down traffic passs through backup route. my sal config is below:-
sla monitor 100
type echo protocol ipIcmpEcho 10.5.5.120 interface Link1
num-packets 3
frequency 10
sla monitor schedule 100 life forever start-time now
=======
show runn routes are :-
route Link1 10.5.5.0 255.255.255.0 10.4.4.5 1 track 10
route Link2 10.5.5.0 255.255.255.0 10.6.6.5 254
Is there any way that i can implement track on 2nd link to destination? because may be after Link1 failure when backup route was it would be able pass traffic to destination, may be link failure between Link router and Destination. Can i monitor backup link if that is active and traffice can pass to destination when 1st Link1 will fail.
Hope u will help me,
AB