02-10-2012 03:23 AM - edited 03-04-2019 03:13 PM
Hi,
I have one problem in my Client end router cisco 1841.
Everyday we switch on the router it will automatically goes to ROMMON mode.
So i take remotly and check wheather the IOS is corrupted or not.
So i use the command dir flash: to check IOS is available or not. i found the IOS is there.But it is not boot from IOS.
So i use the coomand boot xxxx.bin to boot from IOS.and finally it booted.
i am not able to do this work everyday.
Anyone give the permanent solution.
But i search in the internet they give some steps.
They told to use the coomand confreg in the ROMMON mode.
And also i check everything fine.
Kindly give me the solution.