04-11-2012 08:59 AM - edited 03-04-2019 03:59 PM
Trying to establish a reverse telnet session from my Cisco 2620 router's AUX port to a Cisco 2911 Console port. Each time I try to get the connection to my loopback address I get a response saying "Connection to 192.168.0.42 closed by foreign host". I've gone through tons of knowledge articles and believe I have everything set up correctly unless I'm just missing something easy. Using a flat Cisco roll over cable between the two connections.
2620 Loopback IP: 192.168.0.42 255.255.255.255
2620 Aux port configuration:
line aux 0
exec-timeout 0 0
password 7 14141B180F0B
modem InOut
no activation-character
no exec
transport preferred none
transport input all
transport output all
stopbits 1
Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int
0 CTY - - - - - 0 0 0/0 -
65 AUX 9600/9600 - inout - - - 0 0 4452/9572 -
2620-rtr01#clear line aux 0
2620-rtr01#clear line 65
2620-rtr01#telnet 192.168.0.42 2065
Trying 192.168.0.42, 2065 ... Open [Connection to 192.168.0.42 closed by foreign host] I figure it'll just be a simple config change to get it going but I'm at a loss. Any help is extremely appreciated!!