10-11-2013 08:01 AM - edited 03-07-2019 03:59 PM
I just updated my 3850 (2 switch stack) to 3.3.0SE and now when it boots, I see the following erros on the console. Should I be concerned about this? I did not see these before. I'm still testing the switch so it's at my desk and the fans on the switch don't quiet down anymore after the reboot. They stay pretty loud which is unlike other cisco's i've used where they become quiet after the reboot. Again, is there something wrong?
*Oct 11 14:51:48.381: %MGMTINFRA-3-INTERNAL_ERROR: MEMBER: 2 eicored: Failed to import config from /tmp/sw/rp/0/0/rp_platform/mount//usr/binos/etc//eicored/debug_mgr_init_cfg.json (rc=102)
*Oct 11 14:51:48.483: %MGMTINFRA-3-INTERNAL_ERROR: 1 eicored: Failed to import config from /tmp/sw/rp/0/0/rp_platform/mount//usr/binos/etc//eicored/debug_mgr_init_cfg.json (rc=102)
*Oct 11 14:51:49.287: %MGMTINFRA-3-INTERNAL_ERROR: 1 eicored: Failed to import config from /tmp/sw/rp/0/0/rp_platform/mount//usr/binos/etc//eicored/debug_mgr_init_cfg.json (rc=102)
*Oct 11 14:52:06.471: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/0, changed state to down
*Oct 11 14:52:06.472: %LINEPROTO-5-UPDOWN: Line protocol on Interface LIIN0, changed state to up
*Oct 11 14:52:07.672: %MGMTINFRA-3-CFG_PUSH: 1 eicored: Config push failed.please check wcm provider.
*Oct 11 14:52:07.672: %MGMTINFRA-3-CFG_PUSH: 1 eicored: Config push failed (rc=10000) for (wcm) on attributes [{ schedulerEnabled@1 : 10000, rtTimeout@1 : 10000, frameBurst@1 : 10000 }, { schedulerEnabled@1 : 10000, rtTimeout@1 : 10000, frameBurst@1 : 10000 }]
*Oct 11 14:54:59.202: %MGMTINFRA-3-CFG_PUSH: STANDBY:2 eicored: Config push failed.please check wcm provider. (C3850-01-2)
*Oct 11 14:54:59.202: %MGMTINFRA-3-CFG_PUSH: STANDBY:2 eicored: Config push failed (rc=10000) for (wcm) on attributes [{ schedulerEnabled@2 : 10000, rtTimeout@2 : 10000, frameBurst@2 : 10000 }, { schedulerEnabled@2 : 10000, rtTimeout@2 : 10000, frameBurst@2 : 10000 }] (C3850-01-2)