08-11-2013 06:48 AM
Before any other configuration, I upgraded the firmware on a new RV180 from v1.0.0.30 to v1.0.3.10 with the reset to factory default option checked. Then I canceled the Setup Wizard which does not work anyway for static WAN IP assignment. After I manually configured the static IP, when I clicked Save the following error in red text appeared and the RV180 did not save the static IP info.
$| trStrings["11383"] or 'i18nHTMLMissing' |$
I repeated this several times, always with the above result. I even tried the Setup Wizard to see what woulld happen when it finally timed out on network detection but it never timed out - just sat there doing nothing. This was all done with Internet Explorer 9 in both normal and compatibility mode.
I finally downgraded the firmware to v1.0.1.9 which works well on all the other RV180's I have at various clients. Static WAN IP setup was a breeze after the downgrade.
I was hoping that the new firmware was usable but apparently not for static IP's. I'm running 1.0.1.9 on all the RV180 and RV180W units without issue and will stay there until Cisco finally gets this right.
Ed Ruth,
DataNet Services, Inc.