Hi,
We are observing huge increase in Jumbo and Output errors at the TX on one of ourNexus 5596 switch.
Do we have any specific reason and what will be the soulution to fix this?
Please find the interface output.
Ethernet1/24 is up
Dedicated Interface
Belongs to Po324
Hardware: 1000/10000 Ethernet, address: 547f.eefb.ff9f (bia 547f.eefb.ff9f)
MTU 1500 bytes, BW 10000000 Kbit, DLY 10 usec
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA
Port mode is trunk
full-duplex, 10 Gb/s, media type is 10G
Beacon is turned off
Input flow-control is off, output flow-control is off
Rate mode is dedicated
Switchport monitor is off
EtherType is 0x8100
Last link flapped 2week(s) 5day(s)
Last clearing of "show interface" counters 01:02:11
30 seconds input rate 280 bits/sec, 0 packets/sec
30 seconds output rate 35339936 bits/sec, 7590 packets/sec
Load-Interval #2: 5 minute (300 seconds)
input rate 8.32 Mbps, 633 pps; output rate 33.49 Mbps, 7.35 Kpps
RX
1577334 unicast packets 186 multicast packets 4280 broadcast packets
1581800 input packets 990139607 bytes
540658 jumbo packets 0 storm suppression bytes
0 runts 0 giants 0 CRC 0 no buffer
0 input error 0 short frame 0 overrun 0 underrun 0 ignored
0 watchdog 0 bad etype drop 0 bad proto drop 0 if down drop
0 input with dribble 0 input discard
0 Rx pause
TX
27130970 unicast packets 1166 multicast packets 26407 broadcast packets
27158543 output packets 15956581601 bytes
7231723 jumbo packets
260 output errors 0 collision 0 deferred 0 late collision
0 lost carrier 0 no carrier 0 babble 0 output discard
0 Tx pause
0 interface resets
