Hi,
I have two ISP providers. One is DSL and other one is Cable.
DSL connection: 50MB down and 30MB up / Cable 50MB down, 1MB up.
I configured the router with Smart Load Balance, and set-up with values above.
Always when i try to navigate through the internet, the router choose the WAN1, and almost never the WAN2.
In the speedtest, it show just 50MB other than 100 (rare times that it sum both).
How to have a real load balance router configuration ?
I didn't configure rate or priority, also nothing in the protocol binding.
Thanks in advance,
Guilherme
