03-11-2008 11:46 AM - edited 03-18-2019 08:35 PM
I'm trying to configure NM-CUE Cisco Unity Express 3.0.1
I have already set the commands
interface Service-Engine1/0
ip unnumbered GigabitEthernet0/1
service-module ip address 192.168.1.2 255.255.255.0
service-module ip default-gateway 192.168.1.1
If I try to access by the command :
CME#service-module service-Engine 1/0 session
Trying 192.168.1.1, 2066 ... Open
User Access Verification
Username:
A user and pass is asked but I have no configured nither the user nor the pass, is a new module
Is there a default pass in order to access to the module?
I tried to reset the pass via command but this message is displayed:
CME#
Mar 11 18:44:37.521: %SERVICEMODULE-3-PASSWORDRESET: Service module Service-Engine1/0 password reset not supported
C3845-ADVENTERPRISEK9-M), Version 12.4(15)T3
CHow can I have access to the module?