Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

2511 hangs after opening port

I have been struggling for some time now trying to get my 2511 to connect through the octal cable to my other devices. All I get is trying router1....open, but I get no access to the devices on the other side of the connection. Please help.....I have included the config and log for review.

2511-1#router1

Translating "router1"

Trying Router1 (172.16.1.1, 2001)... Open

3 REPLIES
Community Member

Re: 2511 hangs after opening port

try transport input all instead of transport input telnet.

Community Member

Re: 2511 hangs after opening port

Thaks for your help, but I have tried that and also tried it again after your suggestion. Still have the same problem.

Community Member

Re: 2511 hangs after opening port

Not sure if this will help, but here goes:

set the line for:

transport output telnet

Try reverse telnet to your router from another device (PC)

ie >telnet 172.16.1.1 2001

If this does not connect, try setting the line for the following:

line 1/01

no exec-banner

modem InOut

no exec

transport input all

transport output all

escape-character NONE

221
Views
0
Helpful
3
Replies
CreatePlease to create content