i have a problem with my access router 2511, when i connect this router to the switch the ethernet port led is ok ( i use an ethernet convertisor) but i can`t ping this interface and when i connect by console the router reboot evry time, some time this router work normaly and some times it`s like this
is it possible to logon to the router and issue the commands 'show version' and 'show stacks' ? If so, can you post the output of those commands ? Are you trying to connect a with a PC to the router's Ethernet port ? If so, make sure you are using a cross cable...
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...