Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

2811 with NM-2CE1T1-PRI module

I have installed an NM-2CE1T1-PRI module in a Cisco 2811 router and issued the "card type T1 1" command as well as the "controller t1 1/0" and "controller t1 1/1" commands and sub-commands as required, however, the associated serial interfaces never get defined in the router. I am using IOS version:

c2800nm-advsecurityk9-mz.124-17a.bin

Any ideas?

  • Remote Access
1 REPLY
New Member

Re: 2811 with NM-2CE1T1-PRI module

problem resolved .... channel-group command never dropped in from script .....

407
Views
0
Helpful
1
Replies