Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

2851 PRI analogue dialin

I have a Cisco 2851 with a NM-1CE1T1 PRI interface that I wish to utilise for dialin. I have followed some configs on here, however cannot workout the correct line commands.

If I try to add a line via i get an error that it is not supported in hardware - no physical hardware support for line XX.

If I do a show line I get the following output -

Tty Line Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int

* 0 0 CTY - - - - - 0 0 0/0 -

1 1 AUX 9600/9600 - - - - - 0 0 0/0 -

322 322 VTY - - - - - 0 0 0/0 -

323 323 VTY - - - - - 0 0 0/0 -

324 324 VTY - - - - - 0 0 0/0 -

325 325 VTY - - - - - 0 0 0/0 -

326 326 VTY - - - - - 0 0 0/0 -

327 327 VTY - - - - - 0 0 0/0 -

328 328 VTY - - - - - 0 0 0/0 -

329 329 VTY - - - - - 0 0 0/0 -

330 330 VTY - - - - - 0 0 0/0 -

331 331 VTY - - - - - 0 0 0/0 -

332 332 VTY - - - - - 0 0 0/0 -

333 333 VTY - - - - - 0 0 0/0 -

334 334 VTY - - - - - 0 0 0/0 -

335 335 VTY - - - - - 0 0 0/0 -

336 336 VTY - - - - - 0 0 0/0 -

337 337 VTY - - - - - 0 0 0/0 -

Line(s) not in async mode -or- with no hardware support:

2-321

my config is attached.

1 REPLY
Silver

Re: 2851 PRI analogue dialin

You need to define "group-range x y" under your group async.

153
Views
0
Helpful
1
Replies
CreatePlease to create content