Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3640 on ROMMON MODE

I shut down my 3640 router which i use for RAS access and now when i power it up it goes into ROMMON mode,any suggestions on how to get it back to it's normal operating mode without losing the configs on the box..?

3 REPLIES

Re: 3640 on ROMMON MODE

Hi,

Follow the steps here http://www.cisco.com/en/US/products/hw/routers/ps274/products_tech_note09186a008009429f.shtml

Let us know the outcome.

Regards,

Dandy

Hall of Fame Super Silver

Re: 3640 on ROMMON MODE

The link posted by Dandy has helpful information. If that does not lead you to a solution then I would suggest that you post all the console messages that appear during an attempt to boot the router. The console messages may show what the problem is and point toward a solution.

HTH

Rick

Hall of Fame Super Silver

Re: 3640 on ROMMON MODE

This same question is posted in the LAN Switching and Routing forum. I suggest that any further discussion of this be consolidated in the LAN forum.

HTH

Rick

150
Views
0
Helpful
3
Replies