Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Accessing 7613 router from any remote location

I have new configure 7613 router in (siteA) with following Supersivior Engine:-

"NAME: "module 7", DESCR: "WS-SUP720-3B 2 ports Supervisor Engine 720 Rev. 5.6"

PID: WS-SUP720-3B , VID: V05, SN: JAF1209BDGN

NAME: "msfc sub-module of 7", DESCR: "WS-SUP720 MSFC3 Daughterboard Rev. 3.1"

PID: WS-SUP720 , VID: , SN: JAF1209AFPK

NAME: "switching engine sub-module of 7", DESCR: "WS-F6K-PFC3B Policy Feature Card 3 Rev. 2.3"

PID: WS-F6K-PFC3B , VID: V01, SN: JAF1209ARBD

NAME: "module 8", DESCR: "WS-SUP720-3B 2 ports Supervisor Engine 720 Rev. 5.6"

PID: WS-SUP720-3B , VID: V05, SN: JAF1208BHAA

NAME: "msfc sub-module of 8", DESCR: "WS-SUP720 MSFC3 Daughterboard Rev. 3.1"

PID: WS-SUP720 , VID: , SN: JAF1208BEFL

NAME: "switching engine sub-module of 8", DESCR: "WS-F6K-PFC3B Policy Feature Card 3 Rev. 2.3"

PID: WS-F6K-PFC3B , VID: V01, SN: JAF1208AGNB"."

I want to access and configure router remotly ,so that i do not have to visit te (siteA) again and again. ,can anybody help me on this.

1 REPLY

Re: Accessing 7613 router from any remote location

just u need a reachable ip address configured on onof the router interfaces even a loopback interface works but need to be reachable and and configure and allow telnet thats it

telenet could be configured liek

line vty 0 4

password {urpass}

login

also configure enable password on the router

like

enable password [urpassword]

and if u have ACL make sure u have the telnet allowed

if helpful Rate

240
Views
0
Helpful
1
Replies
CreatePlease to create content