Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ADSL WIC configuration on 2821 Router

Could you please help me to configure ADSL Card in Cisco 2821 Series Router

1 REPLY

Re: ADSL WIC configuration on 2821 Router

Hi

A sample config is given below.

interface ATM0

no ip address

no ip redirects

no ip unreachables

no ip proxy-arp

ip route-cache flow

no atm ilmi-keepalive

dsl operating-mode auto

!

interface ATM0.1 point-to-point

description Adsl PPPoe

pvc 8/35

pppoe-client dial-pool-number 1

!

interface Dialer0

ip address negotiated

ip mtu 1452

encapsulation ppp

dialer pool 1

dialer-group 1

no cdp enable

ppp authentication pap callin

ppp pap sent-username xxxx password xxxx

!

dialer-list 1 protocol ip permit

But this may vary from service providers.Some give PPPoE and some with PPPoA.

Pls refer to following link for more :

http://www.cisco.com/en/US/tech/tk175/tk15/technologies_configuration_example09186a008015407f.shtml

Also pls refer the config-builder for pppoe:

http://www.cisco.com/warp/public/794/adslguide_pppoeof.html

and for pppoa

http://www.cisco.com/warp/public/794/adslguide_pppoaof.html

Pls rate helpful posts.

Regards

JD

1067
Views
0
Helpful
1
Replies