My home broadband has just been upgraded to ADSL2 and my cisco 857 doesn't recognise the ADSL line anymore.
Its got 12.4(6). The wan interface is reads ATMoPOTS.
Some forums say that the Firmware needs upgrading. Some say the IOS needs upgrading. one of the Cisco links says only HWIC on the 857s support ADSL2. But its a fixed router - not modular. The only built-in WAN port is ATMoPOTS.
Could anyone provide me with the right advise ASAP please ? We all know how it is without internet access at home !
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...