I have a "slight issue." I have a policy that has spaces in the name on my ASA. This works fine for the software clients, but I tried to configure a router with the ezvpn client, but it doesn't like the spaces. Does anyone know a way around this without creating a new policy for just the hardware clients?
It is better to use policy names without spaces in them as there have been issues with spaces present in the names.I feel it is good to use names avoiding spaces in it as far as possible so that the same name can be used for hardware clients also.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...