Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

as-5350

hi can someone help, i need to set the clock internal in a E1 controller but i cant.

AS-5350

flash:c5350-is-mz.124-9.T1.bin

5350 Software (C5350-IS-M), Version 12.4(9)T1

it is configure

Framing is NO-CRC4, Line Code is HDB3, Clock Source is External.

2 REPLIES
Silver

Re: as-5350

Hi ,

Use "tdm clock priority 1 slot/port " global command

reason :

Configuring Clocking

The time-division multiplexing (TDM) bus on the Cisco AS5350 and Cisco AS5400 backplane

can receive an input clock from one of four basic sources on the gateway:

1.CT1, CE1, and CT3 trunk cards

2.An external T1/E1 clock source feed directly through the Building Integrated Timing Supply (BITS) interface port on the motherboard

3.Free-running clock providing clock from an oscillator

check the below link.

http://cco/univercd/cc/td/doc/product/access/acs_serv/as5350/sw_conf/53swcg/54bas2.htm#xtocid31

http://www.cisco.com/en/US/products/sw/iosswrel/ps5187/products_command_reference_chapter09186a008017d90c.html#wp1140246

Hope it helps you.

Thanks,

satish

New Member

Re: as-5350

thanks

in the configuration i have this

tdm clock priority 1 external

tdm clock priority 2 3/0

but i want internal clock in specifically in

controller E1 3/2

116
Views
0
Helpful
2
Replies