Hi. Actually I've been working with a AS5300 with 120 lines. The AS reports six lines with problems. When I cheked its status, I see this messages ( With SH LINE command ):
Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int
* 2/36 Digital modem - DialIn - - - 0 0 0/0 -
* 2/37 Digital modem - DialIn - - - 0 0 0/0 -
* 2/38 Digital modem - DialIn - - - 0 0 0/0 -
* 2/39 Digital modem - DialIn - - - 0 0 0/0 -
* 2/40 Digital modem - DialIn - - - 0 0 0/0 -
* 2/41 Digital modem - DialIn
If you see the use's column, it is in cero. Of cuourse, those modems has problems. I wrote "clear line" command and the problem is. I shutdown the AS too, but the problem continues. Anybody knows what kind of problem is this? Anybody can help me?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...