Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AS5400 not doing callback

Hi

Have an AS5400 with modem cards and E1 ports, configured for dial backup with callback. Sometimes the callback doesn't complete, and in the debug output we receive the message "no interface available". Soon after in the debug, there is an incoming call in the same interface. It seems that the AS5400, after disconnecting the call to do the callback, received another call, and placed it in the same modem that would be used for callback. This happens even if there are plenty of idle mdems and E1 channels in te equipment. How can we avoid that?

Following is the debug output:

Jul 12 18:30:16.067: As2/05 DDR: PPP callback: Callback server starting to u01005460 0158232234500

Jul 12 18:30:17.067: As2/05 DDR: disconnecting call

Jul 12 18:30:28.231: As2/05 DDR: Dialer statechange to up

Jul 12 18:30:28.235: As2/05 DDR: Dialer received incoming call from <unknown>

Jul 12 18:30:31.067: As2/05 DDR: beginning callback to u01005460 0158232234500

Jul 12 18:31:05.387: As2/05 DDR: re-enable timeout

Jul 12 18:31:05.387: As2/05 DDR: beginning callback to u01005460 0158232234500

Jul 12 18:31:05.387: As2/05 DDR: No interface available for callback to u01005460 0158232234500

Jul 12 18:31:09.235: As2/05 DDR: Dialer statechange to up

Jul 12 18:31:09.235: As2/05 DDR: Dialer received incoming call from <unknown>

Jul 12 18:31:16.067: As2/05: Dialer session up timeout, 277E0410

1 REPLY
Bronze

Re: AS5400 not doing callback

Hi,

If you could upload the following debugs, it would be more helpful for the audience:

debug dialer

debug isdn q931 (disregard if its T1/CAS)

debug modem

debug csm modem

debug chat

debug ppp nego

debug ppp authen

debug aaa authen

debug aaa authoriz

debug callback

If possible, it would be nice to see 'show ver' and 'show run' as well. However, please make sure you hide the username/passwords and ip addresses.

Thanks and Regards,

~Zulfiqar

107
Views
0
Helpful
1
Replies