ASA 5505 8.4(2) (server:80 inside) from (outside:80) NAT/PAT/AC
traffic originated from a low security level destined to a high security levl is denied by default and you must permit the desired traffic by configuring an ACL and applying it inbound on the low security level interface.Since 8.3 you must specify the private IP address of your server in this ACL, not the public IP like before 8.3.
You didn't configure such an ACL and that's why traffic is dropped.
I've never configured AnyConnect so I can't help you for this part but other CSC members will for sure.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...