Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

autoselect ppp problems

Hi,

After upgrading old C2500 analog dial-in router with ext. modem pool and with IOS v.11.2.17 to new C3845 router with int. NM-8AM-V2 and IOS v. 12.4.10 i have folloing problems:

1. ppp session does not starts automatically with

'autoselect ppp' command in configuration

2. ppp session starts only when both 'autoselect ppp' and 'autoselect during-login' are configured, but remote users need access both EXEC-mode and PPP-mode w/o 'autoselect during-login' command and Username prompt.

Any ideas?

Router C2500 with old v.11.2.17 IOS configuration:

...

modemcap entry zyxel:FD=&f*m1s0=1s7=120s10=250:SPD=s20=3:DTE=19200

...

interface Group-Async1

ip unnumbered Ethernet0

ip access-group 105 out

encapsulation ppp

async default routing

async mode interactive

ntp disable

peer default ip address pool ppp_DialIn

no cdp enable

ppp authentication chap

group-range 1 8

...

line 1 8

session-timeout 10

no exec-banner

autoselect ppp

login authentication via_tacacs

modem InOut

modem autoconfigure type zyxel

terminal-type download

no editing

transport input all

escape-character NONE

telnet transparent

stopbits 1

rxspeed 19200

txspeed 19200

flowcontrol hardware

1 REPLY
Silver

Re: autoselect ppp problems

Removing "autoselect during-login" and adding "autoselect timeout 5". Doing this will allow AAA authentication not to be taken immediately after the connection is made.

349
Views
0
Helpful
1
Replies