Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Avocent CPS 1610 problem

I have 2 2801's, 3 3750's and 2 2611's connected to a CPS 1610. I can connect remotely however a few commands won't execute properly. The show running-config" command is accepted but there is a page break after 15-20 lines. In other words I can never get to the middle or end of the running config since it just breaks back to a command prompt too early. Other commands that show multiple pages of output work such as show tech-support. Has anyone experienced this before? I've increased the terminal length but it doesn't really solve the core issue of why a break happens and sends me back to a command prompt too early.

Keith

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: Avocent CPS 1610 problem

  • If not solved, this will solve your problem:
      • port all set out lf=strip

      • port all set in cr=cr (default)

      • port all set in lf=lf

        (default)

      • port all set out cr=cr

        (default)

Best regards

Christoffer

Message was edited by: Christoffer Smoras

1 REPLY
New Member

Re: Avocent CPS 1610 problem

  • If not solved, this will solve your problem:
      • port all set out lf=strip

      • port all set in cr=cr (default)

      • port all set in lf=lf

        (default)

      • port all set out cr=cr

        (default)

Best regards

Christoffer

Message was edited by: Christoffer Smoras

1143
Views
0
Helpful
1
Replies
CreatePlease to create content