Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

BBSM - internet access

BBSM5.3 Pre-Loaded Server

I have configured the BBSM to allow wireless laptop users on the 255 vlan to access the internet. This wireless connection works fine, however when I try to hard wire the laptop directly to the same switch as BBSM and configure the interface to be on the same client network vlan 255. The BBSM comes up with a network error page.

The laptop is being issued with the correct ip address for vlan 255 in both cases and there should not be much difference in the configuration apart from the laptop being hard wired.

Does anyone know what the issue might be ?

1 REPLY
Super Bronze

Re: BBSM - internet access

Yep - I spent ages messing with this product before getting round to reading the documentation properly :-)

Basically you need to make sure you've added the switch as a network device similar to the way you must have done the AP - I assume you've done this.

Secondly, you need to specify the SNMP string with a suffix of the VLAN number in order for BBSM to search the right VLAN.

E.g. your SNMP RW community is:

SNMP

Put in the config:

SNMP@255

Regards

Aaron

Please rate helpful posts....

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
107
Views
0
Helpful
1
Replies