Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

BRI

People,

Troubleshooting isdn basic rates, any idea why a second bearer channel would not want to come up?

Checked the dial strings and config...cant see anything wrong..any suggestions?

Thanx in advanced.

3 REPLIES
New Member

Re: BRI

You may want to verify the following commands in your configuration to bring both bearer channels up (these are entered in the interface command):

ppp multilink

dialer load-threshold load [outbound | inbound | either]

Hope this helps.

New Member

Re: BRI

yes, this is the 1st thing i checked, configs are correct. And on the telco side, what possible problems? Layer 2 comes up, but get a bearer channel error. 1st channel comes up.

Re: BRI

Hi

If possible can you post out the config as well as the exact error logs available out there.

regds

144
Views
0
Helpful
3
Replies
CreatePlease login to create content