We have several routers 2600 and 2800 with BRI interfaces calling to a 3660 with a T1 PRI card, we have exactly the same configuration on all the remote sites (BRI), we are using dialer watch, the mayority of the sites are working however in a few the call disconnect in 20 seconds and we get Cause i = 0x8090 - Normal call clearing, any clue?
An ISDN call will normally be cleared if none of the activation conditions are met and the timeout runs down. This is the interesting traffic that I'm on about. Make sure that you're interesting traffic conditions are being met and that you timeouts are set quite generously.
If you are using dialer-map commands, depending on your traffic types, make sure that you put the broadcast keyword in there.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.