My chat-script doesn't seem to want to dial my modem, as if its not issuing a <CR> at the end of the string.
I've got the 3825 router, with a modem on AUX0 to accept an incoming call, then initiate dial-back. I know the router can send commands to the modem, becuase first, the "offhook" script is called, and the scripts receives and "OK" response, and is happy. Next, 'callback' is called. The following string is set as the callback:
The output on the debug is Sending string "ATDT /T <7639>", then it proceeds to wait 30 seconds to see "CONNECT" come over the DTE. However, the modem goes off-hook, and I hear dial-tone, but never hear any DTMF tones. I tried specifying the '\r' string, to send a carriage return, but only get odd words like "Expecting \017" when I stick that in the chat-script, when viewing the debug.
I've got a 3825 router with a USRobotics Courier 33.6 on the AUX0 port. I'm configured as per all the witepapers on the subject.
Lastly, I can dial in via Hyperterm, and get an EXEC-level login prompt. ALSO, I can dial in PPP, and I can authenticate just fine & get an IP assigned. It's ONLY the dial-back that doesn't work, despite my best efforts. Help!
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...